Warning/Indicator Lamps - Mitsubishi Fuso Canter 2013 Owner's Manual

Table of Contents

Advertisement

6-28
Instruments and warning lamps

Warning/indicator lamps

Z21716
The illustration shows the standard arrangement of
the warning and indicator lamps. Some lamps
shown here, however, may not be installed on your
vehicle.
Illumination of certain warning lamps is accompa-
nied by sounding of a buzzer.
CAUTION
The red warning lamps, if illuminated, warn you
of vehicle component failures and possible dan-
ger of accident. Never drive the vehicle while a
red warning lamp is illuminated. If any of them
light up, stop the vehicle as soon as it is safe to
do so and make checks for locating the cause. If
necessary, have your vehicle repaired by an
authorized dealer.
NOTE:
The red warning lamps may also come on if the
engine is started when the battery's performance
has decreased. In this event, either charge the bat-
tery or replace the battery with a new one.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Fuso Canter 2013 and is the answer not in the manual?

Questions and answers

Daren
March 21, 2025

my ABS light comes on every other time i start the truck

1 comments:
Mr. Anderson
March 21, 2025

The ABS warning lamp on your 2013 Mitsubishi Fuso Canter comes on every time you start the vehicle because it is designed to illuminate when the starter key is turned to "ON" as a system check. It should go out a few seconds later. If the lamp stays on or comes on again, it indicates a malfunction in the ABS. You can check the system by turning the key to "OFF" and then back to "ON." If the warning lamp stays on or comes back on after going off, the ABS system may be faulty and needs inspection.

This answer is automatically generated

Kopule Oke
April 5, 2025

What happened to my fuso bus, signal light fuse blowing when replaced

User image 67f1ba5573bf8
1 comments:
Mr. Anderson
April 5, 2025

The context does not provide a specific reason for the signal light fuse blowing repeatedly in a 2013 Mitsubishi Fuso Canter. However, general causes may include faulty wiring, short circuits, or incorrect installation of electrical equipment. To prevent damage or fire, inspection and repairs should be done by an authorized dealer.

This answer is automatically generated

Table of Contents

Save PDF