Table of Contents
Advertisement
Indication by
PM indicator
When automatic DPF regeneration is in
progress:
• The "CLEANING" message is
displayed.
• PM amount segments flash.
When parked DPF regeneration is in
progress:
The predicted time until completion of
parked DPF regeneration is indicated.
Warning/indicator
• The
(green) lights.
• If a prompt for
parked DPF
regeneration
has been issued
following indica-
tion of 7 or more
PM amount
segments, the
in green and
Z21272
amber alter-
nately.
The
(amber) lights.
Z21273
1.4
Automatic DPF regeneration
•
If the DPF becomes so heavily loaded with PM
that it cannot be regenerated by continuous
DPF regeneration, the system initiates auto-
matic DPF regeneration (regeneration by burn-
ing PM). The
while the DPF is being regenerated by this
method. You can operate the vehicle as usual
even
although the engine operating sound and idling
speed will change due to the higher exhaust
temperature.
Z21276
Parked/automatic
lamp
regeneration
lamp
Automatic DPF
regeneration is in
progress.
lamp lights
Parked DPF
lamp
regeneration is in
progress.
indicator lamp (green) lights
during
automatic
5-53
Ref.
page
5-53
5-55
DPF
regeneration
Advertisement
Table of Contents
Need help?
Do you have a question about the Fuso Canter 2013 and is the answer not in the manual?
Questions and answers
my ABS light comes on every other time i start the truck
The ABS warning lamp on your 2013 Mitsubishi Fuso Canter comes on every time you start the vehicle because it is designed to illuminate when the starter key is turned to "ON" as a system check. It should go out a few seconds later. If the lamp stays on or comes on again, it indicates a malfunction in the ABS. You can check the system by turning the key to "OFF" and then back to "ON." If the warning lamp stays on or comes back on after going off, the ABS system may be faulty and needs inspection.
This answer is automatically generated
What happened to my fuso bus, signal light fuse blowing when replaced
The context does not provide a specific reason for the signal light fuse blowing repeatedly in a 2013 Mitsubishi Fuso Canter. However, general causes may include faulty wiring, short circuits, or incorrect installation of electrical equipment. To prevent damage or fire, inspection and repairs should be done by an authorized dealer.
This answer is automatically generated