Table of Contents
Advertisement
1-8
Recommendation to drivers
•
113-liter fuel tank
The fuel tank is at the rear of the vehicle. To open
the fuel tank cap, slowly turn it counterclockwise. To
close the cap, turn it clockwise until you hear a click.
•
125-liter fuel tank
The fuel tank is on the right-hand side of the vehi-
cle. To open the cap, slowly turn it counterclock-
wise. To close the cap, turn it fully clockwise.
WARNING
•
When filling the fuel tank using a gun-type
Z23257
fuel pump, do not continue pumping after
the pump automatically stops. (The tank is
full at this point.) When filling the fuel tank
using any other method, stop as soon as
the surface of the fuel becomes visible
through the opening of the fuel filler. If you
supply so much fuel that it comes up to
the opening, fuel may leak though the
check valve
moving and when it stops moving. If fuel
leaks, carefully wipe it all up to prevent the
risk of fire.
•
If the pointer of the fuel gauge is above the
"F" mark, do not add the fuel any more.
DEF (Diesel exhaust fluid)
DEF is injected into the exhaust gas inside the muf-
fler in order to break down NOx (oxides of nitrogen)
in the exhaust gas into water and nitrogen, and thus
reduces the amount of NOx.
Fuel tank capacity
113 liters (29.8 gallons)
Fuel tank capacity
125 liters (33 gallons)
when the vehicle starts
P. 5-48
Advertisement
Table of Contents
Need help?
Do you have a question about the Fuso Canter 2013 and is the answer not in the manual?
Questions and answers
my ABS light comes on every other time i start the truck
The ABS warning lamp on your 2013 Mitsubishi Fuso Canter comes on every time you start the vehicle because it is designed to illuminate when the starter key is turned to "ON" as a system check. It should go out a few seconds later. If the lamp stays on or comes on again, it indicates a malfunction in the ABS. You can check the system by turning the key to "OFF" and then back to "ON." If the warning lamp stays on or comes back on after going off, the ABS system may be faulty and needs inspection.
This answer is automatically generated
What happened to my fuso bus, signal light fuse blowing when replaced
The context does not provide a specific reason for the signal light fuse blowing repeatedly in a 2013 Mitsubishi Fuso Canter. However, general causes may include faulty wiring, short circuits, or incorrect installation of electrical equipment. To prevent damage or fire, inspection and repairs should be done by an authorized dealer.
This answer is automatically generated