Table of Contents
Advertisement
6-26
Instruments and warning lamps
3. Turn the starter switch to "ON".
4. If the warning remains displayed but driving in
the manual gearshift mode is possible, take the
vehicle to an authorized dealer for inspection as
soon as possible.
5. If the warning remains displayed and gear shift-
ing is impossible in the manual gearshift mode,
contact your nearest authorized dealer.
2.6
SAM warning
NOTE:
SAM, which stands for Signal Detection and Actua-
tion Module, is a module that integrates the control
and power distribution functions for the electric
equipment of the cab and truck body.
•
Red warning
The red SAM warning is displayed when a failure
occurs in the electric control system of the SAM.
If this warning appears while driving, stop the vehi-
Z21714
cle in a safe place and do the following:
1. Firmly apply the parking brake and move the
gearshift lever to "P".
2. Turn the starter switch to "LOCK".
3. Turn the starter switch back to "ON". If the indi-
cation goes out, there are no problems. If the
warning remains displayed, contact your near-
est authorized dealer immediately.
•
Amber warning
The amber SAM warning is displayed when a failure
(of a type that requires inspection of exterior lamps)
occurs in the electric control system of the SAM.
If this warning appears while driving, stop the vehi-
cle in a safe place and do the following:
1. Firmly apply the parking brake and move the
gearshift lever to "P".
2. Turn the starter switch to "LOCK".
3. Check the exterior lamps for abnormalities.
Replace a blown lamp if any.
4. Turn the starter switch back to "ON".
5. Switch on the replaced lamp. If the warning
goes out, there is no remaining problem with the
SAM.
6. If the warning remains displayed, contact an
authorized dealer as soon as possible.
P. 13-18
Advertisement
Table of Contents
Need help?
Do you have a question about the Fuso Canter 2013 and is the answer not in the manual?
Questions and answers
my ABS light comes on every other time i start the truck
The ABS warning lamp on your 2013 Mitsubishi Fuso Canter comes on every time you start the vehicle because it is designed to illuminate when the starter key is turned to "ON" as a system check. It should go out a few seconds later. If the lamp stays on or comes on again, it indicates a malfunction in the ABS. You can check the system by turning the key to "OFF" and then back to "ON." If the warning lamp stays on or comes back on after going off, the ABS system may be faulty and needs inspection.
This answer is automatically generated