Sharp AL-2020 Service Manual page 41

10) Attach the Scanner motor metal plate cushion covering the bot-
tom part of the Scanner motor lower mylar.
Note: The hole under the motor unit should be covered.
Attach the cushion to cover the gap between the mylar and the
metal plate (the yellow mark).
Stick the lower part of the cushion to the mylar, too.
Press the cushion with a sharp-pointed stick or something to fill
the gap between the mylar and the metal plate.
11) Attach the motor connector and the snap band to the original
position.
12) Attach the Scanner UPG mylar J3 to cover the hole on the right
side of inside of the scanner.
Note: The mylar should cover the hole shown by the arrow in
the diagram.
Attach along with the bent part of the metal plate and align the
edge of the mylar with the line shown in the diagram (the yellow
line in the diagram).
AL-2020/2035/2040/2050/2060 UNPACKING AND INSTALLATION 5 - 12
13) Attach the Fan housing cushion to the cooling fan at the posi-
tion shown in the diagram below.
Cover the top and the right side of the fan housing when you
see the fan housing from the backside of the machine.
Note: Please make sure the double-sided tape is not exposed
where the cushion is sticking out from the edge of the fan
housing.
A
View from Back side
the arrow A
Attach the cushion leaving 3 - 7mm
from the edge.
Attach the cushion leaving 3 - 7mm from the edge so that the
gap between the Fan housing cushion and the filter of the rear
cabinet is filled for sure.
14) Attach the parts removed in the items 1), 2), and 3).
Reference position
3 - 7mm