b. In the Using Ports area, select whether the ports are secure,
nonsecure, or both.
c. Click Next.
7. When the next page appears:
a. Enter an storage system name in the Array Name field.
b. Click Next.
c. Click Finish and proceed to Step
14. Perform the initial setup
After you run the Add Array wizard, use the following procedure to perform
the initial Navigator 2 setup.
1. In the Arrays page, click the name of the storage system you want to
configure.
2. In the following page, under Common Array Tasks, click Initial
Setup.
Figure 1-18: Entering IP Addresses in the Array Wizard
Hitachi AMS 2100/2300 Getting Started Guide
14. Perform the initial
setup.
25