Attaching the front bezel to the modular 2U SAS expansion unit is also
optional. To attach it:
1. Insert the key into the keyhole on the front bezel and unlock the lock.
2. Grasp the front bezel on both sides and above the center of the unit.
3. Engage the two hooks at the bottom of the front bezel into the slots on
the array chassis.
4. Push the front bezel toward the chassis to engage it into the ball catches.
5. Remove the key from the front bezel and store it in a safe place.
7. Attach expansion units (optional)
If you do not have expansion units, skip to
1. Connect one expansion unit to the base unit:
a. Use a supplied ENC cable to connect the PATH#0 port on controller
0 to the ENC0 IN port on the rear of the expansion unit.
b. Use a supplied ENC cable to connect the PATH#0 port on controller
1 to the ENC1 IN port on the rear of the expansion unit.
c. Gather the excess part of the ENC cable in a circle, tighten it gently
and secure, and place it inside the rack.
2. To connect a second expansion unit to the base unit:
a. Use a supplied ENC cable to connect the PATH#1 port on controller
0 to the ENC0 IN port on the second expansion unit.
b. Use a supplied ENC cable to connect the PATH#1 port on controller
1 to the ENC1 IN port on the second expansion unit.
c. Gather the excess part of the ENC cable in a circle, tighten it gently
and secure, and place it inside the rack.
3. To connect additional expansion units, follow the pattern in
on page
Figure 1-4: Location of PATH#0 and PATH#1 Ports (Base Unit)
10
12.
Hitachi AMS 2100/2300 Getting Started Guide
page
13. Otherwise:
Figure 1-6