Miele KFN 14943 SDE ED Operating And Installation Instructions page 58

Changing the door hinging
^ Remove the cover
Now the soft-close mechanism and the
appliance are no longer connected.
^ Remove the panel
^ Push the shock absorber arm
far as possible towards the handle
side.
^ Loosen the three screws
soft-close mechanism and the
spacer.
^ In the middle, pry out the housing
with the soft-close mechanism using
a flathead screwdriver.
^ Then, pry the housing with the
soft-close mechanism out of the
retainer from the appliance side.
^ Lay the soft-close mechanism aside.
^ Push out the spacer towards the
hinge side.
^ Lay the spacer aside.
58
.
.
as
on the
Removing the top door of the
appliance:
^ Loosen the cover
sliding a flathead screwdriver from
below into the recess.
^ Remove the cover
the mounting bracket
^ Loosen the mounting bracket
the cover by pushing it slightly to
the left and then removing the cover
plate towards the front.
^ Turn the mounting bracket
^ Place the cover
the mounting bracket
to the right. The writing must be
visible.
^ Unscrew the bearing
turn it 180° and replace it on the
opposite side. If necessary,
pre-punch the screw holes.
^ Remove the top cover
it from back to front and lifting it up.
^ Remove the cover
by carefully
together with
.
from
180°.
onto the front of
and push it
mechanism,
by pushing
upwards.