Installation Instructions; Electrical Connection - Blomberg DHP 24400W Owner's Manual & Installation Instructions

3

Installation Instructions

A
WARNING - Risk of fire
• The clothes dryer ("appliance') installation must be
performed by a qualified installer.
• Install the appliance according to the
manufacturer's instructions and local codes.
• Do not install a clothes dryer with flexible plastic
venting materials. If flexible metal (foil type) duct
is installed, it must be of a specific type identified
by the ap pliance manufacturer as suitable for use
with clothes dryers. Flexible venting materials are
known to collapse, be easily crushed, and trap lint.
These conditions will obstruct the clothes dryer's
airflow and increase the risk of fire.
• To reduce the risk of severe injury or death,
follow all installation instructions.

3.1 Electrical connection

Connect the appliance to a grounded outlet protected by
a fuse or circuit breaker of suitable capacity.
Dryer shipped with cord to fit this
type 4 -wire receptacle
4-wire r eceptacle
(14 -30R)
If yo u have 3-wir e recep tacle, like
this , a 3-wire dryer cord mu st be
purc hased locall y.
3-wire r eceptacle
(10 -30R)
3-Wire Electrical Connection
If your receptacle is a 3-wire receptacle as shown
below, you must obtain a 3-wire dryer cord. A dryer
cord can usually be found at your local hardware
supply, electrical supply or home center. Cord should
have closed loop or upturned end wire terminating
connectors. The cord kit must be marked "For Use with
Clothes Dryers".
10 / 28 EN
3- wire receptacle
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
If the dryer is installed in a mobile home,
recreational vehicles, new branch-circuit
A
installations or in areas where local
codes do not permit grounding through
the neutral conductor, only a 4-wire
power supply cord shall be used.
To change the cord:
1. Make sure that the dryer is not plugged into any
power outlet.
B
DO NOT plug end of dryer power cord
into a live receptacle before connecting
dryer power cord to dryer terminals and
closing junction/splitter box as described
below.
B
DO NOT repair old power supply cords.
Power cord must be changed only by a
qualified person. There is a risk of electric
shock!
2. Remove the screw from the cover of the junction box
located at the top rear of the dryer.
3. Remove the red, white and black wire from the
terminal block.
4. Remove the green ground wire from the ground
terminal.
5. Loosen the strain relief clamp holding the 4-wire
cable.
6. Thread the 4-wire cable out through the strain relief
clamp.
7. Thread the new 3-wire dryer cord through the strain
relief clamp.
8. Attach the power cord Ground conductor (the center
wire) to the terminal labeled N. Connect the
terminal labeled N and the Ground terminal labeled
G. Tighten the terminals so that they securely hold
the conductors.
( 10-30R)
Dryer / User Manual