Siemens SINUMERIK 840D Diagnostics Manual page 519

10.04
Reactions:
Remedy:
Program Continuation:
112211
Definitions:
Reactions:
Remedy:
Program Continuation:
112300
Definitions:
Reactions:
Remedy:
Program Continuation:
112301
Definitions:
Reactions:
Remedy:
Program Continuation:
112323
Definitions:
Reactions:
Remedy:
Program Continuation:
112324
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Alarm display.
Free memory space must be created on the NC, and it must be enough for the program to
be processed (e.g. by deleting programs that are no longer required).
Internal
Tool preselection could not be processed. Insufficient NC memory.
When tool preselection is processed, the NC program has to be generated again. Hereby
the old NC program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new
program.
The tool preselection is not processed.
- Alarm display.
Free memory space must be created on the NC, and it must be enough for the program to
be processed (e.g. by deleting programs that are no longer required).
Internal
Tool management type 2 not possible. Magazine not completely loaded.
The magazine is not completely loaded with tools.
In the magazine of tool management type 2, the number of tools specified in machine
data 18082 has to be created.
- Alarm display.
Installation and start-up: Create the correct number of tools.
Internal
Tool management type 2 not possible. The magazine is not sorted as in the tool list.
The magazine list sorting does not correspond to that of the tool list.
In the magazine of tool management type 2, the sequence of the tools has to be defined
according to their T numbers.
- Alarm display.
Installation and start-up: Assign the tools according to their T numbers to the magazine
locations.
Internal
Replace swivel head.
The operator is prompted to remove the specified swivel head from the spindle.
- Alarm display.
Replace swivel head.
When doing this, please follow the machine manufacturer's instructions.
Internal
Load swivel head.
The operator is prompted to load the specified swivel head into the spindle.
- Alarm display.
Load swivel head.
When doing this, please follow the machine manufacturer's instructions.
Internal
1 Alarms
1-519