Siemens SINUMERIK 840D Diagnostics Manual page 109

10.04
Remedy:
Program Continuation:
10745
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10746
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10747
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 WAB end position not clear
%1 = Channel number
%2 = Block number, label
In the WAB block and in the following block, the position has been programmed perpen-
dicular to the machining direction. In the WAB block, no position has been indicated in the
machining plane.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program. Either remove the position data for the infeed axis from the WAB
block or the following block, or program a position in the machining plane in the WAB
block as well.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 block search stop for WAB
%1 = Channel number
%2 = Block number, label
A block search stop has been inserted between a WAB approach block and the following
block defining the tangent direction or between a WAB approach block and the following
block defining the end position.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 retraction direction not defined for WAB
%1 = Channel number
%2 = Block number, label
In a WAB retraction block with quarter circle or semi-circle (G248 or G348), the end point
in the machining plane was not programmed, and either G143 or G140 without tool radius
compensation is active.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program. The following changes are possible:
• Indicate end point in the machining plane in the WAB block.
• Activate tool radius compensation (effective for G140 only, not for G143).
• State retraction side explicitly with G141 or G142.
• Perform retraction with a straight line instead of a circle.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-109