Casio DT-X200 Series User Manual page 46

4. Turn on the power switch on the right side of the USB Cradle. The power LED on the
front of the USB Cradle lights red.
5. Align the terminals on the bottom of the DT-X200 with the power supply terminals
in the USB Cradle before inserting the DT-X200 (
the USB Cradle until the mount hooks in the cradle engage the mount holes in the
DT-X200(
Check that the power LED on the front of the USB Cradle lights green and that
indicator 1 on the DT-X200 lights.
To remove the DT-X200 from the USB Cradle, tilt the DT-X200 forward to disengage
the mount hooks from the mount holes and then lift the DT-X200 out of the cradle.
Status of Indicator 1 on DT-X200:
Orange:
Red Flashing: Standby due to battery pack error or the surrounding temperature is out
Green:
Status of Indicator 2 on DT-X200:
Blue Flashing:
Orange Flashing:
Magenta Flashing: Ready to communicate.
E-44
).
Charging the battery pack.
of the charging temperature range.
(charging begins when the temperature is within the charging temperature
range)
Charging the battery pack is complete.
Operating via Bluetooth
Operating via WLAN.
). Push the DT-X200 fully into
®
.