Operation - Makita M583 Instruction Manual

3
2
1
4
004032
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
CAUTION:
The inner flange has a 20 mm diameter on one
•
side and a 19 mm diameter on the other. The side
with 19 mm diameter is marked by "19". Use the
correct side for the hole diameter of the blade you
intend to use. Mounting the blade on the wrong
side can result in the dangerous vibration.
1 2
3
004033
Side grip (auxiliary handle) (Accessory)
004034
Align the hole in the grip holder with the hole in the blade
case (upper blade guard) and secure the grip holder
onto the blade case using the screw as shown in the
figure. Securely screw the side grip clockwise into the
hole in the grip holder.
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
1. Mounting shaft
6
2. Inner flange
3. 19 mm marking
4. Saw blade
5. Outer flange
6. Hex bolt
5
4
Hex wrench storage
004035
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

OPERATION

CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the blade making any contact. Then
turn the tool on and wait until the blade attains full speed.
Now simply move the tool forward over the workpiece
surface, keeping it flat and advancing slowly until the
sawing is completed. To get clear cuts, keep your
sawing line straight and your speed of advancing
uniform.
005339
Rip fence (Guide rule)
2
005340
7
1. Screw
2. Rip fence
1