Makita 8413 Instruction Manual page 5

Specific Safety Rules
1. Hold tool by insulated gripping surfaces w h e n performing an operation where
the cutting tool may contact hidden wiring. Contact w i t h a "live" wire will
also make exposed metal parts of the tool "live" and shock the operator.
2.
Be aware that this tool is always in an operating condition, because it does
n o t have t o be plugged i n t o an electrical outlet.
3.
Always be sure you have a f i r m footing.
Be sure no one is below w h e n using the tool in high locations.
4. Hold the tool firmly.
5. Keep hands away from rotating parts.
6. Do not leave the tool running. Operate the tool only w h e n hand-held.
7.
Do not touch the drill bit or the workpiece immediately after operation; they
may be extremely hot and could burn your skin.
SYMBOLS
The followings show the symbols used for
tool.
v
....................................
volts
....................................
direct current
n ,
....................................
no
load
speed
.../
min
...................................
revolutions or reciprocation per minute
b
....................................
number
of
blow
5