Table of Contents
Advertisement
4 Hardware Installation
1.
Use the provided L-wrench, loosen the tamper-resistant housing cover (with
screws still attached on the cover). The unit has a factory installed side conduit
entry and one may adjust the cables to back conduit entry according to
installation requirement.
2.
Set the mounting base onto the wall or ceiling and center it over the mounting
hole, using the supplied two retaining screws to secure the main body.
3.
Set the proper image by moving the camera body (some model may be limited by
the PCB board to180° rotational adjustment) and set the focus by turning the lens
to the left or right direction.
4.
Connect video output cable (BNC) to a TV monitor. Once the picture appears on
the monitor, adjust the lens wrench to "TELE←→WIDE" of the lens, get the view
zoom that you desire, and then adjust the focus wrench to "NEAR←→FAR" of
the lens to obtain the best clear picture. After adjustment, tighten both wrenches.
Honeywell
9
Advertisement
Table of Contents
