Chapter4 Interactive Voice Response Menu; Overview; Menu Commands - Linksys WRP400 User Manual

Chapter4
Chapter :
Interactve Voce
Response Menu

Overview

This chapter explains how to use the Interactive Voice
Response (IVR) Menu to configure the Router's network
settings. Use your telephone's keypad to enter your
commands and select choices, and the Router will use
voice responses.
To access the IVR Menu:
1. Use a telephone connected to the Phone 1 or 2 port of
the Router. (You can only access the IVR Menu through
an analog telephone, not any of the Internet phones.)
2. Press **** (in other words, press the star key four
times).
3. Wait until you hear
"Configuration menu. Please enter the option followed
by the # (pound) key, or hang up to exit".

Menu Commands

Refer to the following table that lists actions, commands,
menu choices, and descriptions. After you select an
option, press the # (pound) key. To exit the menu, hang
up the telephone.
If the menu is inactive for more than one minute, the
Router will time out. To re-enter the menu, press ****.
Wreless-G Broadband Router wth 2 Phone Ports
the Router's response,
Interactive Voice Response Menu
Acton Command Choces Descrpton
Enter IVR
****
Menu
Check DHCP 100
Check IP 110
Address
120
Check
Subnet
Mask
Check Static 130
Gateway IP
Address
10
Check MAC
Address
Check 10
Firmware
Version
33
Factory Confirm -
Press 1.
Reset of the
Router
Cancel -
Press *
Warning:
(star).
All custom
settings
will be lost,
including
the network
and service
provider
data.
Use this command
to enter the IVR
Menu. Ignore
Special Information
Tones (SITs) or other
tones until you
hear, "Configuration
menu. Please enter
the option followed
by the # (pound)
key, or hang up to
exit. "
The IVR announces
whether DHCP is
enabled or disabled.
The IVR announces
the current IP
address of the
Router.
The IVR announces
the current subnet
mask of the Router.
The IVR announces
the current gateway
IP address of the
Router.
The IVR announces
the MAC address
of the Router in
hexadecimal string
format.
The IVR announces
the version number
of the firmware
running on the
Router.
After the
Router requests
confirmation, press
1 to confirm.
After you hear,
"Option successful",
hang up the phone.
The Router will
reboot, and all
settings will be reset
to their defaults.
3