Scene Setup - Honeywell Tuxedo Touch Series Installation And Setup Manual

Scene Setup

The Scene feature is used to control a single device, or multiple devices based on pre-set "Conditions,"
"Triggers," and "Actions". When a trigger/condition occurs, the defined action is executed. Define a
Scene as follows:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon and then
press the Scene Setup icon to display the
"Scene Management" screen.
b) Press the Add icon to set up a Scene.
c) Press the Name box, enter a Scene
Name and press OK.
d) Select a "Condition," "Trigger," and
"Action" that you want to occur for this
Scene. See example below. After each
selection press Save!! !
Scene Icons
Add
Scene Rules
• Triggers and Conditions include: Time setting, Security mode, Thermostat setting, Door status and
Zones..
• Actions include: Security mode, Lights on/off, Thermostat setting, and Door Lock status.
• Each Trigger event can have up to 3 Actions.
• A Trigger event and Condition cannot be the same (i.e., if setting a Trigger event for SECURITY,
you cannot set a SECURITY Condition).
• A total of 10 Scenes can be created.
• On commercial panels the programming option for "Global Keypad" must be set to "0" for some
Scenes to work properly.
Note: Determine if you need a Condition. The Condition is a 'pre-condition' set to occur prior to a
trigger event. See example below.
Example: Turn the lights on, when the system is disarmed, only at night.
(Condition)
... "only at Night"
(Trigger) ...
...when the "system is Disarmed" ...Set the Trigger to SECURITY: System Disarm
(Action) ...
Turn the "lights ON" ...
Automation (cont'd)
ACTION
Delete
Edit User
...Set the TIME condition (enter the Start Time End Times)
... Set the Action to LIGHT: ON.
Enter the new device name by entering it on the
data entry keyboard.
• Use the Shift icon for capital letters.
• Use the BS (Backspace) icon to make
corrections.
The @#$ icon is not available for use at this time.
Manual Run option – Allows you to manually run a
defined scene (for example to test a newly defined
scene). When defining a Scene, set the Manual Run
option by selecting the Scene and pressing the Edit
icon. Select the Manual Run option and press Save.
To activate, press the Run button.
After each selection is complete, press Save to keep
the settings, press Delete to cancel, or Edit to
change your selections.
31
NOTES