Options; Operating Modes - Honeywell Tuxedo Touch Series Installation And Setup Manual

RIS Automation Address
If using Remote Services, set the RIS (Remote Interactive Services) address to the appropriate RIS
address for using Total Connect. To change the address, perform the following:
ICON
1. Press the ECP Address icon.
1
2. Select the RIS Address for this keypad
2
3
using the Up/Dn arrows.
3. The available RIS addresses are
(1-30) and is defaulted to 25.

Options

Options allows you to enable "Options" for Lighting, EN50131 Display, Weather Forecast and
Commercial; and "Operation Modes" for "Normal Mode", "Safe Mode", "Demo Mode" and
"Automation Mode".
Screen Blackout Feature (EN50131 Display)
The Screen Blackout (EN50131 Display) compliance feature is a European Standard designed to prevent
unauthorized users from viewing the status of the Security System. When the EN50131 Display feature
is enabled:
• The keypad returns to the "Home" screen after 30 seconds; "Armed" and "Ready" LEDs turn OFF.
• The "To Homepage After" time setting changes to 30 seconds and the time is non-selectable.
• The "Auto Slideshow After" is preset to "1" minute and can not be changed.
• The Security, Message and Lighting screen does not display system status until an authorized user
code is entered.
• The "Setup" menu does not display system status until an authorized user code is entered.
• Videos can not be played.
From the Home screen, press the Setup and System Setup icon.
ICON
1. Press the CS Setup and enter your Authorized
Code, if required.
2. Press the Options icon.
3. Select options "Lighting", "EN50131 Display" or
Weather Forecast to turn the option on or off.
Apply accepts all changes.

Operating Modes

From the Home screen, press the Setup and System Setup icon.
ICON
1. Press the CS Setup and enter your Authorized
Code, if required.
2. Press the Options icon.
3. Select Operation Modes "Normal Mode", "Safe
Mode", or "Automation Mode/Demo Mode" to
turn the option on or off.
- Press Apply and then OK; the keypad resets and
activates changes.
System Setup (cont'd)
ACTION
ACTION
ACTION
17
NOTES
NOTE: If using remote services, one of the touch-
screen device (AUI) addresses is used by the control
panel. Refer to control panel Instructions for specific
configuration.
The Weather feature can be completely
disabled if Tuxedo Touch is used in an
area not supported by the weather service
or the user does not want to see weather
on the Home screen.
*Night option must be enabled in the
Night Setup menu before the Night
button will operate.
Press the following icons:
System Setup> Advanced Setup >Night
Setup> select Night and then press
Apply.
NOTES
NOTES