Enroll A Door Lock; Enroll A Honeywell Thermostat - Honeywell Tuxedo Touch Series Installation And Setup Manual

Enroll a Door Lock

Assemble the Z-Wave door lock. NOTE: Be sure the door lock orientation/handedness is correct.
Refer to the Door Lock's Instruction Guide and connect necessary cables, then install batteries. Enroll
the door lock within 5 ft of the keypad refer to the Door Lock's Instruction Guide for enrollment
procedure.
NOTE: Program the user code in the control panel prior to programming that user code into the door
lock. User Codes must be 4-digits. Enroll a door lock device as follows:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) Press the Z-Wave Enroll/Add icon.
2. At the door lock:
a) Program the selected user code from
the panel; refer to Door Lock User
Guide.

Enroll a Honeywell Thermostat

Install a Honeywell Thermostat according to the manufactures instructions. Device should be mounted
in the final location and tested before adding it to the system.
To enroll a Honeywell Thermostat into a Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) Press the Z-Wave Enroll/Add icon.
2. At the Z-Wave thermostat:
a) Select Thermostat; set the Time and
Date.
b) Follow the instructions in the
thermostat Installation Guide for
"Z-Wave inclusion".
c) To complete inclusion, press Done.
d) Press Exit on the thermostat to
return to normal operation.
3. At the Tuxedo Touch Keypad:
a) To verify activation, press the Back
icon and wait 30 seconds.
Automation (cont'd)
ACTION
ACTION
28
NOTES
Note: Door lock devices may vary; follow the
instructions in the Users Guide for your specific door
lock to enroll properly and to program a new user
code.
The keypad displays a series of messages:
"Please press *Function key on device"
"Adding to Security Network"
"Device added successfully"
* Enrollment procedure may vary depending on the
door lock device. Refer to the door lock instructions
for enrollment procedure.
Note: If software is upgraded on the Tuxedo Touch
keypad, enroll the door lock again and re-set the user
code in the door lock.
NOTES
Note: If installing another brand of thermostat, follow
the instructions in the Users Guide for that specific
thermostat to enroll properly.
Some thermostats do not update temperature status
automatically (i.e., Wayne Dalton).
IMPORTANT: Honeywell is not responsible for
property damages due to improper setting of the
thermostat modes.
The keypad displays a series of messages:
"Please press *Function key on device"
"Adding Controller Unit"
"Adding Slave Unit"
"Device added successfully"
* If not using a Honeywell thermostat enrollment
procedure may vary. Refer to the thermostat
instructions for enrollment procedure.
Press the Refresh icon; the device is displayed.