Led Test; Calibration Test; Z-Wave Test - Honeywell Tuxedo Touch Series Installation And Setup Manual

Audio Test
ICON
1. Press the Audio Test icon; "Testing.." is
displayed while beeps sound from the
speaker.
At the conclusion of the test, a pop-up "Confirmation
Window" is displayed with the question "Did you hear
Beeping?"

LED Test

ICON
1. Press the LED Test icon; "Testing.." is
displayed while the 3 LEDs light
sequentially, top to bottom (red, green,
yellow), 5 times.

Calibration Test

ICON
1. Select the Calibration icon and using a
stylus, follow the screen directions by
pressing a series of crosshairs (+) and boxes
( ) on the screen until done.
2. If the test was successful, press OK.
3. If the test was unsuccessful, choose to Retry,
Ignore or Exit.

Z-Wave Test

NOTE: This procedure is for Z-Wave test purposes only.
Role shifting is the process of shifting primary and secondary controllers. The secondary controller
becomes the primary controller with the ability to enroll Z-Wave devices. This is useful when the
primary controller is in a fixed location and the Z-wave device is not easily accessible (but within Z-
wave range). To perform the role shifting Z-Wave Test, do the following:
ICON
1. Press the Advanced Setup icon.
2. Enter your Authorized Code.
3. Press the Keypad Test icon.
4. With the status of the controller in the "P"
(Primary) state, press the Z-Wave Primary
Controller Shift to Secondary icon.
A pop-up window is displayed with the
following warning: "
controller shift function is for evaluation only now.
This primary controller is shifting to the secondary.
Please wait until the process completes.
User System Setup (cont'd)
ACTION
ACTION
ACTION
ACTION
Warning!! This Z-Wave
24
NOTES
When you press Yes, "Passed" is displayed in
the test status column on the "Diagnostics"
screen.
When you press No, "Failed" is displayed in the
test status column on the "Diagnostics" screen.
NOTES
At the conclusion of the test, a pop-up
"Confirmation Window" display: "Did you see
chasing LED pattern?"
If you press Yes, "Passed" is displayed in the
test status column on the "Diagnostics" screen.
If you press No, "Failed" is displayed in the test
status column on the "Diagnostics" screen.
NOTES
If the Calibration test was successful, a
confirmation screen appears stating:
"Congratulations Calibration Successful!!!"
If the test was unsuccessful, an error message
appears indicating the Part of the screen that
failed and stating: "Calibration failure, do you
want to retry?"
NOTES
Select from two main categories of tests:
• Z-Wave Role Shifting: Primary to Secondary
and Secondary to Primary.
• Z-Wave Basic Command: Set On or Off.
Note: The status of the controller can only be
changed from Primary to Secondary controller
when no devices are enrolled.
Use the delete device or reset controller function
to remove enrolled devices.