Casio QT-2000 Service Manual page 68

Operation: (1) Connect QT-2000s with ARCNET (inline) cable.
(2) On the reception unit, press [n][m][m][m][4][2][SUB TOTAL].
n = number of execution. Should be within 0 to 9. If 0 or no number is input, the execution
continues endlessly.
mmm = ID number of the unit from which the data is sent.
To stop the test press [ESC].
Display: <LCD>
ARC–RX
peer–node:mmm
ARC–RX OK:xx NG:xx
END
R/J print:
ARC–RX
END
(3) On the transmission unit, press [n][m][m][m][4][1][SUB TOTAL].
n = number of execution. Should be within 0 to 9. If 0 or no number is input, the execution
continues endlessly.
mmm = ID number of the unit to which the data is sent.
To stop the test press [ESC].
Display: <LCD>
ARC–TX
peer–node:mmm
ARC–TX OK:xx NG:xx
END
R/J print:
ARC–TX
END
42
Associated unit's ID number
42
0
42
42
41
Associated unit's ID number
41
0
41
41
— 66 —
<Dot/7-segment>
Dot/7-segment display indicates 0 only when
the test is continued from the "Dot/7-segment
display test." When the test is performed
indipendently, the dot/7-segment display indi-
cates nothing.
<Dot/7-segment>
Dot/7-segment display indicates 0 only when
the test is continued from the "Dot/7-segment
display test." When the test is performed
indipendently, the dot/7-segment display indi-
cates nothing.
0
0