System Tones - Honeywell Domonial User Manual

SYSTEM TONES

TOTAL SET
ARMING
PART SET
ARMING
ANNEX SET
ARMING
EXIT DELAY
ARMING
COMPLETE
ENTRY DELAY
DISARMING
FAULT
ALERT
* Defined by user during the installation
Sequence of 3 modulated sounds
Duration : 4 seconds
Sequence of 2 modulated sounds
Duration : 2,5 seconds
Upon arming...
one beep every second
After closing the final door
Three fast beeps
Upon entry...
one beep every second
Long and continuous beep
Duration : 2,5 seconds
2 times 7 fast beeps
4 beeps in case of alert...
sent via the keypad
When arming, total set, confirms that the
control panel has received a valid code or
TAG and is preparing to arm total set.
When arming the part set, confirms that the
control panel has received a valid code or
TAG and is preparing to arm part set.
Total set arming: beeps continue until final exit
door is closed
Part set arming: beeps continue for 30s* until
part set is armed
When closing the final exit door, confirms that
the system is armed.
This entry tone sounds for 30 seconds* after
you open the entry door. You should disarm
your system within this time.
When Disarming, confirms that the control
panel has been successfully disarmed.
This signal indicates a fault in the system
Confirms the transmission of an alert to the
Alarm Receiving Centre
7