Duress Code - Honeywell Domonial User Manual

●
RESETTING THE SYSTEM AFTER AN ALARM
If LED 3, 4 or 5
has occurred and restored. When an alarm is in memory, the system will not arm until it has been
reset.
To reset the system, simply disarm the system using a valid code or programmed key TAG.
If there is more than one alarm in memory, repeat this operation for each alarm in memory until
LED 3, 4 and 5 stop flashing slowly.
If LED 5 is flashing quickly on your alarm panel, this indicates a confirmed alarm has
occurred and a remote reset is required. In this case the system will not operate. To remotely reset
your system call your alarm company :
●

DURESS CODE

✔ A duress code can be used if you are forced to disarm your security system under duress.
Your duress code is +1 to your code (1234 => 1235, 6789 => 6780).
The system will disarm as normal however a silent alert signal is transmitted to your Alarm
Receiving Centre.
●
WRONG CODE PROTECTION
If your enter 5 successive wrong codes, the keypad is blocked for 5 minutes.
●
SENDING A PANIC SIGNAL
You can send an instant panic alarm whenever you feel threatened whilst at home:
✔ Press and hold the "SOS" key simultaneously :
✔ The siren is triggered (depending on configuration),
✔ The Alarm Receiving Centre is alerted.
The "PANIC" function is operative even when your system is not armed.
is flashing slowly on your control panel, this indicates an alarm
11
+