Honeywell Domonial User Manual page 10

●
ARMING WITH FAULT
If the system diagnoses a fault on arming, arming is prevented. Faults include system faults, tam-
pering and triggering of detectors.
✔ A tone indicating a fault is emitted by the panel siren after the arming request, instead of the
arming tone.
✔ You can override prevention of arming by requesting arming a second time within 2 minutes
after the first request. This will bypass faults.
✔ The arming process restarts: the arming tone is emitted by the panel siren followed by the exit
delay beeps. Completion of arming remains the same.
●
DISARMING USING CODE OR TAG
To enable you to get to the keypad without triggering an alarm, your installer has programmed an
entry delay of 30 seconds. (Depends on site configuration)
✔ Enter a valid code or present a programmed TAG,
✔ A green light on the keypad confirms that the code is valid,
- The disarming tone is
panel siren.
✔ Disarming the system will also stop the sirens if an alarm is triggered.
Stopping the siren does not interrupt the transmission of the alarm to the ARC.
Note: Depending on your keypad's configuration, this will disarm the total set or the entire
system. In the latter case, the annex set might need to be re - a r m e d .
emitted by the
18 10