Enabling Or Disabling The Quick Connection Mode - ViewSonic SC-T35 User Manual

4.2.8

Enabling or Disabling the Quick Connection Mode

The Quick Connection mode enables you to enter the ViewSonic Quick Connection screen after system startup.
This setting is enabled by default.
NOTE
• For detailed instructions on how to use your SC-T35 under the Quick Connection
mode, please refer to section "3.1 Learning the Basics" on page 14.
• There are three similar but different modes for your SC-T35 and only one mode
will take effect if all are enabled. Three modes and the order of priority are
listed as follows:
NOTE
• To use the Quick Connection mode, ensure that both the Appliance and Autostart
modes are disabled. By default, your SC-T35 is in the Quick Connection mode, and
both the Appliance and Autostart modes are disabled. However, if either of two
modes are enabled, the Quick Connection mode will fail to work.
• For more information on the Appliance mode, please refer to section "4.2.7 Enabling
or Disabling the Appliance Mode" on page 43.
• For more information on the Autostart mode, please refer to the following sections:
No. Mode Description
The client will start up directly with the desired
1 Appliance RDP / ICA / View session and turn off after
existing the session.
The client will start up directly with the desired
RDP / ICA / View session and perform the
configured action after existing the session.
Available actions include:
2 Autostart
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
The default. The client will enter ViewSonic
3 Quick Connection
Quick Connection screen after system startup.
— "4.6.5 Configuring Advanced RDP Connection Settings" on page 111
— "4.6.8 Configuring Advanced ICA Connection Settings" on page 145
— "4.6.11 Configuring Advanced View Connection Settings" on page 172
Configuring Client Settings
Configuring System Settings
47