Adjusting Controller Operations; Calibrating Knob And Fader Alignment - Casio XW-PD1 Trackformer User Manual

Adjusting Controller Operations

You can use the procedures in this section to adjust
TRACKFORMER faders, knobs, pads, and other
controllers whenever operations seem to be misaligned
or otherwise different from what you expect.
Calibrating Knob and Fader
Alignment
You can use this procedure to calibrate the positions of
the knobs and faders below.
VALUE knob, FX1 knob, FX2 knob, MIX FADER,
ASSIGNABLE fader
1.
While holding down sequence step key 16,
press the P (power) button to turn on power.
2.
Press sequence step key 1.
3.
Press the PLAY selector button.
4.
Rotate all of the above knobs to the left as far
as they will go, and move the faders all the
way to the left.
5.
Press the PLAY selector button.
This will start calibration of the knob and fader
operations to their far left positions.
• The message (rotate right) shown below will appear
on the display when calibration is successful.
6.
Rotate all of the above knobs to the right as
far as they will go, and move the faders all the
way to the right.
7.
Press the PLAY selector button.
This will start calibration of the knob and fader
operations to their far right positions.
• The message (center) shown below will appear on the
display when calibration is successful.
8.
Move the VALUE knob, MIX FADER, and
ASSIGNABLE fader to their center positions.
9.
Press the PLAY selector button.
This will start calibration of knob and fader operations
to their center positions.
• The message (End) shown below will appear on the
display when calibration is complete.
10.
Press the P (power) button to turn off
TRACKFORMER.
NOTE
• To cancel calibration part way through, press the
EXIT button. Canceling calibration part way
through also discards any positions that were
calibrated up to that point.
• An error message (
occurs during calibration. Pressing any button other
than EXIT at this time will return to the previous
display message. Make sure knobs and faders are in
the correct positions (left, right, center) as you
perform calibration again.
) will appear if an error
EN-20