Casio XW-PD1 Trackformer User Manual page 17

Grouping Pads
Sounding a grouped pad while the sound of another
one of the group's pads is sounding will cause the
previous pad's sound to stop. TRACKFORMER
supports configuration of two groups per bank. This
function is supported only while TRACKFORMER
settings are configured as described below.
Tone type of all pads: Drum
Pad tones: Sound or sample
1.
Enter the PAD ACTION mode.
2.
Press a pad you want to include in the group.
3.
Press sequence step key 8 (Group 1) or 9
(Group 2) to assign a group number.
This causes the sequence step key you pressed to flash
and adds the pad you selected in step 2 to the group.
• To remove the pad from the group, press sequence
step key 8 or 9 again so the key stops flashing and
remains lit.
4.
Repeat steps 2 and 3 to add other pads to the
group.
Entering the TOGGLE Mode
You can configure a pad to remain depressed until you
press it a second time.
1.
Enter the PAD ACTION mode.
2.
Press the pad you want to configure.
3.
Press sequence step key 11 so it is flashing.
This puts the pad in the TOGGLE mode.
• Each press of sequence step key 11 toggles the
TOGGLE mode between enabled (flashing) and
disabled (lit).
Mastering TRACKFORMER Operations
Configuring the Effect Target
You can configure settings so effects are applied to a
particular bank, or to the internal sound source or
external sound source only.
NOTE
• This setting can be changed while the pad type is
effect.
1.
Enter the PAD ACTION mode.
2.
Press the pad you want to configure.
3.
Use the sequence step keys to select the
effect target.
Sequence
Display
Setting Step Key
Message
Status
All 13, 14,
15: Lit
Current 13: Flashing Effects are applied to
Bank
Internal 14: Flashing Effects are applied to
External
Bank 1 15: Flashing Select the bank to
Bank 2
Bank 3
Bank 4
Description
Effects are applied to all
sounds.
the currently selected
bank only.
the internal sound
source (Internal) or
external sound source
(External) only. Each
press of this key cycles
the setting in the
following sequence:
Internal sound source
3 External sound
source 3 Disabled
(Off).
which you want to
apply the effect. Each
press of this key cycles
the setting in the
following sequence:
Bank 1 3 Bank 2 3
Bank 3 3 Bank 4 3
Disabled (Off).
EN-15