Optional Accessories; Replacing The Carbon Brushes - Makita DHP446 Instruction Manual

Replacing the carbon brushes

1
006258
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove two screws then remove
the rear cover.
011500
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver with a slender shaft or the like.
1
2
011501
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the new
ones and replace the carbon brush caps in reverse.
1
011502
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
1. Limit mark
1. Rear cover
1
2. Screw
2
1. Recessed part
2. Spring
3. Arm
3
1. Carbon brush
cap
1
2
006304
Reinstall the rear cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use the accessories or
attachments for their stated purposes.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Drill bits
•
Tungsten-carbide tipped hammer bit
•
Phillips bit
•
Slotted bit
•
Socket bit
•
Blow-out bulb
•
Safety goggles
•
Hook
•
Bit holder
•
Makita genuine battery and charger
•
NOTE:
Some items in the list may be included in the tool
package as standard accessories. They may differ from
country to country.
10
1. Hole
2. Carbon brush
cap
or attachments are