Makita DHP446 Instruction Manual
Cordless hammer driver drill makita dhp446/ dhp456
Hide thumbs
Also See for DHP446:
- User manual ,
- Instruction manual (76 pages) ,
- Instruction manual (61 pages)
Related Manuals for Makita DHP446
Summary of Contents for Makita DHP446
- Page 1 INSTRUCTION MANUAL Cordless Hammer Driver Drill DHP446 DHP456 011491 IMPORTANT: Read Before Using.
-
Page 2: Specifications
The following show the symbols used for the equipment. to EN60745: Be sure that you understand their meaning before use. ･ Read instruction manual. Model DHP446 ･ Sound pressure level (L ) : 80 dB (A) Only for EU countries... - Page 3 Avoid body contact with earthed or grounded EC Declaration of Conformity surfaces such as pipes, radiators, ranges and Makita declares that the following Machine(s): refrigerators. There is an increased risk of Designation of Machine: electric shock if your body is earthed or grounded.
- Page 4 Personal safety 21. Maintain power tools. Check for misalignment 10. Stay alert, watch what you are doing and use or binding of moving parts, breakage of parts common sense when operating a power tool. and any other condition that may affect the Do not use a power tool while you are tired or power tool’s operation.
- Page 5 accessory contacting a "live" wire may make exposed Avoid storing battery cartridge in a metal parts of the power tool "live" and could give the container with other metal objects such as operator an electric shock. nails, coins, etc. Hold power tool insulated...
-
Page 6: Functional Description
Battery protection system FUNCTIONAL DESCRIPTION (Lithium-ion battery with star marking) CAUTION: 1. Star marking Always be sure that the tool is switched off and the • battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1. -
Page 7: Speed Change
Lighting up the front lamp Speed change 1. Speed change 1. Lamp lever 011495 011503 CAUTION: CAUTION: Always set the speed change lever fully to the Do not look in the light or see the source of light • • correct position. -
Page 8: Operation
The hook is convenient for temporarily hanging the tool. Adjusting the fastening torque This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool 1. Action mode housing on either side and then secure it with a screw. To changing ring remove, loosen the screw and then take it out. -
Page 9: Maintenance
Blow-out bulb (optional accessory) Drilling operation First, turn the adjusting ring so that the pointer points to 1. Blow-out bulb marking. Then proceed as follows. CAUTION: Pressing excessively on the tool will not speed up • the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. -
Page 10: Optional Accessories
Only use the accessories or attachments for their stated purposes. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. 011500 Drill bits Raise the arm part of the spring and then place it in the •... - Page 12 Makita Jan-Baptist Vinkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan www.makita.com 885240A225...