Audio Soundsandalerts Ringvolume; Audio Defaultvolume - Cisco TelePresence SX20 Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents
Audio SoundsAndAlerts RingTone
This setting defines which ringtone to use for incoming calls. You need to enter the exact name
of the ringtone. You can find the available ringtones the following ways.
Web interface: On the Configuration > Personalization page.
Touch controller: On the Ringtone & Sound panel of the Settings menu. This panel is either
in the open part of the Settings menu, or included in the password protected Administrator
menu. The UserInterface UserPreference setting defines which panels will be in the password
protected area.
Remote control: Under Sounds and Alerts in the Settings menu on screen.
API: Run xCommand Audio SoundsAndAlerts Ringtone.
Requires user role: USER
Value space: <S: 1, 100>
Format: String with a maximum of 100 characters.
Audio SoundsAndAlerts RingTone: "Sunrise"
Example:

Audio SoundsAndAlerts RingVolume

Sets the ring volume for an incoming call.
Requires user role: USER
Value space: <0..100>
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.
Audio SoundsAndAlerts RingVolume: 50
Example:

Audio DefaultVolume

Set the default speaker volume. The volume returns to this value when you switch on or restart
the video system. You can also run the following API command to return to the default value:
xCommand Audio Volume SetToDefault. Run the xCommand Audio Volume commands, or use
the remote control or Touch controller to change the volume while the video system is running.
Requires user role: USER
Value space: <0..100>
Range: The value must be between 0 and 100. The values from 1 to 100 correspond to the
range from -34.5 dB to 15 dB (0.5 dB steps). The value 0 means that the audio is switched
off.
Audio DefaultVolume: 50
Example:
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings
Audio Volume
Set the speaker volume. This setting is obsoleted by the Audio DefaultVolume setting.
Requires user role: USER
Value space: <0..100>
Range: The value must be between 0 and 100. The values from 1 to 100 correspond to the
range from -34.5 dB to 15 dB (0.5 dB steps). The value 0 means that the audio is switched
off.
Audio Volume: 50
Example:
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
62
Administrator Guide
Setting passwords Appendices