Connecting Linktheater To The Display - Buffalo LinkTheater PC–P3LWG/DVD User Manual

Connecting LinkTheater to the Display

Please follow the illustrations below to connect LinkTheater to the display. There are three methods of
connecting video and three methods of connecting audio. LinkTheater came with a Composite (RCA) cable
that will connect LinkTheater to a display. If you prefer to utilize other connectors, please purchase the
proper cables and install them following the diagrams below. It is important to note that any combination
of audio and video connectors can be used and not all combinations are illustrated below. Please consult
your sound receiver's and/or your display or television's user manuals to determine the best set of connectors
to use.
Please begin by connecting the included AC Power cable into the AC In port on the back of LinkTheater.
Then, plug the AC Power cable into a power outlet. If you are using an Ethernet cable to connect your
LinkTheater into your network, then plug the CAT5 Ethernet Cable into the Ethernet port on the back of
LinkTheater.
Setup Using Composite Video:
TV Mode: The default TV Mode will be used when using the composite video connector.
(Y)(W)(R)
Setup Using S-Video:
NOTE: The included composite cable can be used for this setup, just use the red and white audio connectors only.
The yellow composite video connector can be left unplugged on both the LinkTheater and the display or TV.
TV Mode: The default TV Mode will be used when using the S-Video connector.
(Y) (R)(W)
Included Composite Cable
(W) (R) (W) (R)
Composite Audio Cable
S-Video Cable
Video Audio
Connector Connector
Audio
S-Video
Connector
13