Table of Contents
Advertisement
Display Settings:
The LinkTheater supports four display modes. Changing the
display modes could result in your LinkTheater not operating
properly so please make sure you know which modes your TV or
monitor supports:
Composite 480i 4x3 – This is the standard mode. It utilized
the standard RCA (yellow) video cable or S-Video to transmit
video data. 480i means the picture is displayed at the resolution
640x480 interlaced.
Component 480i 4x3 – This mode uses the same resolution
as above but transmits the image over the D4/component video
connectors. Your TV or monitor must support D4 or component
video to use this mode.
Component 480p 4x3 – This is identical to the mode above,
requiring a TV or monitor with D4 or component video, however,
this mode uses 640x480 progressive resolution. This is the
same resolution that a progressive scan DVD player would use.
If your TV or monitor doesn't support 480p/progressive than this
mode will NOT work.
Component 720p 16x9 – This mode utilizes HDTVs at HD
resolutions over the D4/component video connectors. This is the
highest and recommended setting if your TV or monitor supports
it. Most widescreen HDTVs should support this mode. It uses
1280x720 progressive resolution. If your TV or monitor doesn't
support 480p/progressive than this mode will NOT work.
Please check with your TV or monitor's documentation and
specifications to determine which mode you would like to use.
NOTE: The LinkTheater can only transmit on video signal on
RCA/composite and S-Video simultaneously. It cannot transmit
on D4/component and composite or D4/component and S-Video
simultaneously.
46
Advertisement
Table of Contents
