Obihai OBi1062 Administration Manual page 198

CallForwardOnNoAnswerEnable
CallForwardOnNoAnswerNumber
CallForwardOnNoAnswerRingCount
BlockedCallers
MaxSessions
AnonymousCallBlockEnable
AnonymousCallEnable
DoNotDisturbEnable
Inbound Direct Dialing Authentication (VoiceService.1.X_P2P.1.VoiceGateway.)
AuthMethod
Enable call forwarding of all incoming calls when the call is
not answered after a period as specified in
CallForwardOnNoAnswerRingCount. If
CallForwardOnNoAnswerNumber is blank, this parameter is
treated as if it has been set to No.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Directory number to forward all incoming calls when the
call is not answered after a period specified in
CallForwardNoAnswerRingCount
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Number of rings to be considered by the device as no
answer to an incoming call.
Note: 1 ring is approximately 6s
A comma separated list of up to 10 caller numbers to block
from calling this service
The maximum number of simultaneous calls that may be
established on this service
Enable blocking of Anonymous Calls on this service.
Anonymous calls are rejected with a SIP 486 (Busy)
response and Call Forward On Busy service is not applied.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Enable masking of Caller-ID information for all outgoing
calls. If enabled, the called party should perceive the call as
coming from an anonymous caller.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Enable Do Not Disturb Service. If enabled, all incoming calls
on this service are treated as if the device is busy.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
The OBiTALK protocol allows incoming calls to indicate a
target number that is different from this device's OBi
number. The device in that case will attempt to establish
and bridge the call to the target number according to the
rules configured in the trunk's InboundCallRoute
parameter. Hence this device acts as a gateway and the
method is referred to direct dialing or 1-stage dialing
(versus 2-stage dialing via the Auto-Attendant). Since the
caller is not able to enter a PIN in such cases, an automated
method based on signaling protocol must be used to
authenticate the caller if authentication is required. OBi
Copyright 2010-2015 Obihai Technology, Inc.
false
2
2
false
false
false
HTTP Digest
198