Obihai OBi1062 Administration Manual page 194

CallForwardOnNoAnswerNumber
CallForwardOnNoAnswerRingCount
BlockedCallers
MWIEnableMask
X_VMWIEnableMask
MessageWaiting
AnonymousCallBlockEnable
AnonymousCallEnable
DoNotDisturbEnable
X_BridgedOutboundCallMaxDuration
X_AcceptDialogSubscription
is not answered after a period as specified in
CallForwardOnNoAnswerRingCount. If
CallForwardOnNoAnswerNumber is blank, this
parameter is treated as if it has been set to No.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Directory number to forward all incoming calls when
the call is not answered after a period specified in
CallForwardNoAnswerRingCount
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Number of rings to be considered by the device as no
answer to an incoming call.
Note: 1 ring is approximately 6s
A comma separated list of up to 10 caller numbers to
block from calling this service
Enable Message Waiting Indication from this service on
one or more phone ports. It is specified as a bit mask,
such that bit 0 for Phone 1, bit 1 for phone 2, etc.
Enable Visual Message Waiting Indication for this
service on one or more phone ports. It is specified as a
bit mask, such that bit 0 for Phone 1, bit 1 for phone 2,
etc.
This is a state rather than a configuration parameter,
that indicates if there are any new messages for this
subscriber on the service provider's voicemail system
Enable blocking of Anonymous Calls on this service.
Anonymous calls are rejected with a SIP 486 (Busy)
response and Call Forward On Busy service is not
applied.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Enable masking of Caller-ID information for all outgoing
calls. If enabled, the called party should perceive the
call as coming from an anonymous caller.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Enable Do Not Disturb Service. If enabled, all incoming
calls on this service are treated as if the device is busy.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Limit on the call duration in seconds for all outbound
calls that are bridged from the same or another trunk. A
blank or 0 value implies the call duration is not limited.
Enable the device to accept SUBSCRIBE to this trunk's
Copyright 2010-2015 Obihai Technology, Inc.
2
255
255
false
false
false
false
false
194