Set Up Your Modem Router For Cable Or Fiber Service - NETGEAR D6100 User Manual

AC1200 WiFi DSL Modem Router—Essentials Edition Model D6100
c. Enter the MAC address of the computer or router with which you previously were
able to connect to the Internet.
You might find the MAC address on the product label of your device. Enter the
MAC address in the AABBCCDDEEFF format, not in the AA:BB:CC:DD:EE:FF
format.
d. Click the Next button.
20. If the Congratulations! screen still does not display and the modem router still does not
connect to the Internet, do the following:
a. Review all your settings.
Make sure that you selected the correct options and entered everything correctly.
b. Run the Setup Wizard one more time.
c. Contact your ISP to verify that you are using the correct configuration information.
d. Read Troubleshoot the Internet Connection
e. If problems persist, register your NETGEAR product and contact NETGEAR
technical support.

Set Up Your Modem Router for Cable or Fiber Service

You can install your modem router for cable or fiber (Ethernet WAN) service or for DSL
service. If you use a cable or fiber modem, follow the procedure that is described in this
section. If you use a DSL modem, follow the procedure that is described in
Router for DSL Service and Access the Modem Router
The following figure shows the cabling of your modem router for cable or fiber service.
Install and Access the Modem Router and Its Network
on page 210.
on page 20.
26
Cable the Modem