Cisco SPA 301 Quick Start Manual page 3

Installing the Cisco SPA
301 IP Phone
Step 1
Turn the phone body over to expose
the ports on the back of the unit.
Step 2
Insert the long end of the phone cord
into the handset port on the phone
body that is marked with a phone
symbol (labelled 2).
Step 3
Insert the other end of the phone
cord into the port at the bottom of
the receiver.
0800 040 8888
v1 - 06/13
Step 4
Connect your phone to the network
using one of the methods below:
•
Using an Ethernet connection
Insert one end of the Ethernet cable into the
network port on the phone body marked 'WAN'
(labelled 3).
Insert the other end of the Ethernet cable into
the appropriate device, such as a network
switch, on your network.
• Using a wireless connection
You can use a Cisco WBP54G Wireless-G
Bridge with the IP phone to create a wireless
connection between the phone and the network.
See the WBP54G documentation on
www.cisco.com for more information.
Step 5
Insert one end of the power cord
into an outlet and insert the other end
of the power cord into the power port
on the phone body (labelled 1).
NB
To power the phone through the Ethernet
connection, use the optional Cisco POES5
5-Volt Power Over Ethernet Splitter accessory.
See the Cisco POES5 documentation on
www.cisco.com for more information.
Step 6
(Optional) To install the phone on a
vertical surface, use the Cisco MB100
Wall Mount bracket. See the Cisco
Small Business IP Phone SPA 300
Series User Guide (SIP) or the Cisco
Unified Communications Manager
Express for the Cisco Small Business
IP Phone SPA 300 Series documents
on www.Cisco.com for more information.
After your phone is successfully connected to the
network and receives a basic configuration, you
should hear a dial tone when picking up the receiver.
working with daisy
www.daisygroupplc.com