Safety Warnings; Installing An Sfp Module - Cisco 860 Series Hardware Installation Manual

Chapter 3 Connecting the Router
•
•

Safety Warnings

Laser Safety Warnings
Optical SFPs use a small laser to generate the fiber-optic signal. Keep the optical transmit and receive
ports covered whenever a cable is not connected to the port.
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
Class 1 laser product. Statement 1008
Warning
Do not stare into the laser beam. Statement 1010
Warning
Warning Invisible laser radiation present. Statement 1016
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard. Statement 1056
Use of controls, adjustments, or performing procedures other than those specified may result in
Warning
hazardous radiation exposure. Statement 1057

Installing an SFP Module

To connect and secure the SFP module, follow these steps:
Slide the SFP into the SFP port connector until it locks into position (see
Step 1
If the SFP uses a bale-clasp latch (see
Tip
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-04
Removing an SFP Module, page 3-34
Online Insertion and Removal, page 3-35
Connecting a Small-form-factor Pluggable Module
Figure 3-31), the handle should be on top of the SFP module.
Figure 3-31).
3-33