9. Set the quarter glass (A) in the opening, and center
i t . F r o m i n s i d e t h e v e h i c l e , m a k e a n a l i g n m e n t m a r k
(B) to the quarter glass where the rear clip will be
installed with a grease pencil. Be careful not to
l o u c h t h e g l a s s w h e r e a d h e s i v e w i l l b e a p p l i e d .
10. Remove the quarter glass.
1 1 . A l i g n t h e u p p e r c l i p { A ) a n d l o w e r c l i p ( B ) w i t h t h e
edge of the quarter glass (C), then anach them with
adhesive tape (NITTO 571, or equivalent) to the
inside face of the quarter glass, and align the center
of the rear clip (D) with the alignment mark (E) you
made in step 9, and attach it with adhesive tape (3
M 4215, or equivalent) to the inside face of the
quarter glass as shown. Be careful not to touch the
glass where the adhesive tape will be applied.
25.5 mm
{ 1 . 0 i n . )
(cont'd)
20-31