Honeywell 7000 Product Data page 5

Place the empty control panel box in the correct location on
the plywood and mark the location of the mounting holes on
the plywood. If necessary, drill pilot holes at these locations.
Mount the control panel box using properly sized screw
anchors (not supplied) or other secure mounting techniques.
See Fig. 2 and 3.
CAUTION
Equipment Damage Hazard.
Static discharge can damage circuit board.
Follow ESD safety procedures when installing or
handling circuit board.
Circuit Board Installation
Mount the control panel printed circuit board in the metal
control panel box on the four standoffs and guides, using the
four screws and four lockwashers supplied.
Circuit Board Wiring
The control panel circuit board is the central wiring point for
most of the system. Connections are available for:
a. Loop wiring.
b. Smoke detector wiring.
c. Backup batteries.
BRICK, CONCRETE OR
CINDER BLOCK WALL
MOUNTING HARDWARE
FOR PLYWOOD
Fig. 3. Mounting the control panel enclosure on plywood.
HONEYWELL 7000 SOLID STATE ALARM SYSTEM
3/4 IN. (19 MM)
PLYWOOD
CONTROL BOX
d. External bell/horn.
e. Ac connections.
f. Earth ground.
g. Telephone interface connection.
h. HBus devices (keypad, PEM, RFEM, etc.).
Wiring instructions for each of these connections or devices
are provided in the appropriate section.
WARNING
Electrical Shock Hazard
Can cause serious injury or death.
Disconnect power before wiring
General
1. Protect all wiring entering the control panel box with
strain relief and bushings.
2. Use adhesive-backed cable tie mounts and cable ties
to secure the wiring to a convenient point inside the
control panel box.
3. Use two No. 6 screws to secure the control panel box
lid after wiring is completed.
See Fig. 4 for general information on circuit board wiring.
5
M10909
69-1192—1