Honeywell LYNX Touch Series Installation And Setup Manual page 44

LYNX Touch Installation and Setup Guide
Programming the Control
Update Server
This procedure is used to upload the Configuration File to the Server.
SCREEN
Comm. Diagnostics
Setup
Communication
Yes
During the upload process the following messages may be displayed:
Message
Updating Root File...
Programming Done
Updating Configuration – Try Later!
Cannot Upload – Try Later!
Update Root File – Failed!
1. Select "Comm. Diagnostics" The System displays the following options depending upon
the communication device that is installed:
Communication
Status
Communication
ID Numbers
2. Select "Setup Communication". The System advances to the Registration screen and
the following options are displayed:
Register
Device
Update
Server
3. Select "Update Server" and select "Yes" when the confirmation screen appears. The
device uploads its entire configuration file to the server. Selecting "No" will cancel the
operation. (Refer to the table below for applicable registration messages.)
The root file is being uploaded.
Indicates the root file has been successfully uploaded.
Error message indicates the module is busy
Error message indicates the communication path(s) is not available.
Error message indicates an error while uploading root file..
WWW.DIYALARMFORUM.COM
ACTION
Ethernet
Information
Test
Communication
Register Device
With PIN
Factory
Defaults
Meaning
- 44 -
GSM
Information
Setup
Communication