Honeywell LYNX Touch Series Installation And Setup Manual page 42

LYNX Touch Installation and Setup Guide
Programming the Control
Register through AlarmNet Direct Website
If you have programmed the communications module through AlarmNet Direct, you must then transfer the
data to the module, and register the module.
To do this, please go to: https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx.
Log in and follow the on-screen prompts.
If you are not signed up for this service, click on "Dealer Signup" from the login screen to gain access to the
Honeywell web-based programming.
Dealer Sign-Up Direct Link: https://services.alarmnet.com/AlarmNetDirectP_Sign-Up.
You will be instructed how to proceed upon completing the sign-up form. Only one sign-up per dealer is
required. Once an initial user is established, additional logins may be created by that user.
Please have the following information available when programming the device:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on outside of box and on label inside module – location to be
confirmed).
Once module is registered, you may log out of the AlarmNet Direct website.
Register by Phone
You can register the module by calling the AlarmNet Technical Assistance Center (TAC) at 1-800-222-6525.
You will need the following information:
• MAC number (found on the label).
• Subscriber information (provided by the central station), including a city code, CSID, and a subscriber
ID.
• When instructed to do so, select Register Device in the LYNX Touch Diagnostics to complete the
registration.
Register through LYNX Touch Diagnostics
You can register the module using the LYNX Touch Diagnostics by the following the following procedure.
SCREEN
Comm. Diagnostics
Setup
Communication
1. Select "Comm. Diagnostics" The System displays the following options depending upon
the communication device that is installed:
Communication
Status
Communication
ID Numbers
2. Select "Setup Communication". The System advances to the Registration screen and
the following options are displayed:
Register
Device
Update
Server
3. Select "Register Device".
for the acknowledgement. (Refer to the table below for applicable
registration messages.)
Note: Register Device can be cancelled by selecting "Cancel". The registration process is
aborted and the message Registration Cancelled! is displayed.
WWW.DIYALARMFORUM.COM
ACTION
Ethernet
Information
Test
Communication
Register Device
With PIN
Factory
Defaults
The registration message is sent and the unit waits
- 42 -
GSM
Information
Setup
Communication