Detailed Port Statistics - Draytek VigorSwitch G1240 User Manual

24 gigabit port web smart switch
Hide thumbs Also See for VigorSwitch G1240:
Table of Contents

Advertisement

Parameter description:
Maximum Frame support
up to 9600 bytes
Drop frames after excessive
collisions
Enable Power Saving
Link
Mode
Flow Control
Flow Control Status
Port Description
3
.
3
.
2
D
e
t
a
i
l
e
d
P
o
3
.
3
.
2
D
e
t
a
i
l
e
d
P
o
The function of Detailed Port Statistics collects any information and provides the counting
about the traffic of the port, no matter the packet is good or bad.
In the following figure, the window can show only one port counter information at the
same time. To see another port's counter, you have to pull down the list of Select, then you
will see the figures displayed about the port you had chosen.
This function supports jumbo frames of up to 9600 bytes.
Check the check box to enable it.
In general, 1500 bytes frame sizes are supported by
Ethernet. With this feature checked, the frame size can be
extended up to 9600 bytes. In comparison with small
frame, the CPU load can be reduced and the throughput
can be increased.
Drop frames after excessive collisions.
After an excessive collision, the MAC drop frames might
occur. If yes, a frame is dropped after excessive collision.
This is IEEE Standard 802.3 half-duplex flow control
operation.
Check this box to enable the power saving mode for the
switch.
Show link status of this port.
Set the speed and duplex of the port. If the media is
1Gbps fiber, there are several modes to choose: Auto, 1
Gbps FDX and Disabled. If the media is TP, the speed is
Auto, 1Gbps FDX/10 Mbps FDX /100Mbps FDX /10
Mbps HDX/100 Mbps HDX and Disabled.
In Auto mode, no default value.
You can Just tick the check box ( ) to enable flow
control. If flow control is set Enable, both parties can
send PAUSE frame to the transmitting device(s) if the
receiving port is too busy to handle. When it is set
Disable, there will be no flow control in the port. It drops
the packet if too much to handle.
Default: Disable
Display if flow control is enabled or disabled. In default,
it is disabled.
Description of device ports can not include " # % & ' + \.
r
t
S
t
a
t
i
s
t
i
c
s
r
t
S
t
a
t
i
s
t
i
c
s
44
VigorSwitch G1240 User's Guide

Advertisement

Table of Contents
loading

Table of Contents