Troubleshooting Guide - Hitachi PXR-D Instruction Manual

9. Troubleshooting Guide

9-1 Troubleshooting Guide
If the printer does not normally start up, perform the following checks before you
jump to the conclusion that the printer is defective.
Phenomenon
The power does not turn
ON at the press of the
power ON/OFF switch.
Pressing a key does not
invoke its predefined
operation.Or the key is
not accepted.
The calendar time is not
correctly printed.
The printer does not
become ready for
printing at pressing the
Start up key.
A fault message is
displayed.
Entering a remote
control signal will not
cause the system to
function.
¡If the above remedies do not restore the printer to normal,
stop using the printer, disconnect the power plug from the
power outlet, and contact your Hitachi distributor.
Report the following to your local source or service company:
1. TYPE-FORM (model number)
2. SER. No. (serial number)
3. Failure description
4. Organization name (department and section names included), name of person
in charge, and telephone number
* The model number and serial number are marked on the nameplate that
is attached to the right-hand side of the printer.
Check
¡Check that the power
plug is properly connected
to a power outlet.
¡Check that electrical power
is supplied to the
employed power outlet.
¡See Section 5.4, Calibrating the Touch Screen
Coordinates.
¡See Section 1.2.10, Protection Sheet for touch panel.
¡Check that "clock stop" is
not selected from the
date/time setup screen.
See Section 4.3, Setting
the Date and Time.
¡Check for an ink stream
ejection from the nozzle.
¡Check whether the
ejected ink stream enters
the gutter hole.
See Section 8, If a Warning Condition/Fault Occurs.
¡Is the confirmation
window on?
¡Is the Touch screen
coodinate on?
¡Is the circulation control
screen on?
CAUTION
IJ printer Model PXR-
PXR
In detail
Solution
¡Turn OFF the power
switch. Ensure that
power is supplied the
power outlet, and then
connect the power plug to
the power outlet.
¡Select the "same as
current time" option.
See Section 4.3, Setting
the Date and Time.
¡Stop the ink ejection
sequence by pressing
the Shut down key.
¡See Section 7.6,
Correcting a Bent Ink
Stream and Clogged
Nozzle, and correct the
problem.
¡Close the window or
display another screen,
then enter a signal
again.