Setting Character Height And Character Orientation - Hitachi PXR-D Instruction Manual

For rotary encoder wiring
and setup, see Section
1.5.3-6, Rotary encoder
signal.
For the 40 m nozzle
machine, a ink drop use
percentage setting of 1/1 is
not available.
3-35

Setting Character Height and Character Orientation

3.4 Setting Character Height and Character
Orientation
1 Overview
¡The procedure for setting the character height, character width, character
orientation and print start delay is described below.
The "Print specifications" first screen.
Print specifications
Message name
Character height
Character width
Character orientation [ ] ( :
Arrow: Printing direction
Printing method
Repeat intervals
Repeat count
Print start delay
Target sensor timer
Target sensor filter
Setup value
1 2
1
Character height
¡The character height can be specified.
¡The character height setting range is from 0 to 99.
2 Character width
¡ The character width can be specified.
¡The character width setting range is from 0 to 199.
¡When the product speed matching feature is incorporated (when the rotary
encoder is connected), set the character width as indicated below.
Ink drop use percentage setting
3
Character orientation
¡Printing direction of characters can be set.
¡Settings and print results are as shown below.
Setting
Status: Ready
2011.07.07 12:45
[ ] (
[ ] (
:
(1: single scan 2: Interlaced
[ ] scanning unit SC
[ ] (0: none, 1-9998, 9999: continuous)
[ ] (scanning unit SC
[ ] (1/10 sec 0: none, 1-999)
[ ] (1: time setup 2:until end of print. )
[ ] (msec 0-9999)
3 4 5 6 7
1/1
1/2
1/3 to 1/16
Direction of transport Printing results
Com=0
Start Shut
up down
Comm
Manual
On/Off
: :
Show
cursor
)
Prev.
Next
0-9999)
set- set-
tings tings
0-9999)
Character
unit CH
Scanning
8 9 0
unit SC
Incre-
Decre-
Back
ment
ment
Character width setting
002
001
000
Direction of transport