Connecting Electric Power Tools; Installing The Holder - Makita VC1310L Instruction Manual

symbol.

Connecting electric power tools

WARNING:
Observe the maximum connected loads for the
•
appliance socket (Refer to the SPECIFICATIONS.)
Make sure that both the cleaner and the electric
•
power tool are switched off before connecting or
disconnecting. Connecting the power tool to the
cleaner with both of them being switched on may
cause unexpected and sudden start resulting
serious personal injury.
1
2
011595
When connecting a grounded tool, insert a plug with a
grounding plate to the socket of the cleaner.
CAUTION:
Never connect an electric power tool with an input
•
power exceeding
SPECIFICATIONS " to the socket of the cleaner by
turning the suction
Connecting the electric power tool exceeding the
specified input power may cause overheat and
damage to the cleaner. Refer to the specifications
to avoid this.
The cleaner can be connected to an electric power tool
up to input power shown in the " SPECIFICATIONS ".
To connect an electric power tool, open the cap and
insert the power tool plug into the socket of the cleaner.
1
011594
Rotate the switch lever to the " AUTO " position.
Move the suction force adjusting knob to the position
suitable for the input power of the electric power tool you
intend to use. Refer to the SPECIFICATIONS for the
relation between suction force adjusting knob and the
3 1. Cap
2. Power supply
cord
4
3. Suction force
adjusting knob
4. Switch lever
that specified in
force adjusting
1. Suction force
2
adjusting knob
2. Switch lever
electric power tool input power.
Switching on and off of the connected electric power tool
simultaneously brings the cleaner switching on and off
action. The cleaner still works for a few seconds even
after the electric power tool is switched off.
After use, disconnect the power tool from the socket of
cleaner.
Switch off the cleaner after use.
Auto-suction stop during suction operation
WARNING:
Do not use for a long time while the float is at
•
work. Using the cleaner with its float at work for a
long time can cause overheat, resulting in the
cleaner deformation.
Do not pick up foam or soapy liquid. Picking up
•
foam or soapy liquid can cause foam to come out of
air exit before the float works. Continuing to using in
this condition may cause an electric shock and
breakage of the cleaner.
The cleaner has a float mechanism that prevents water
from immersing into the motor when picking up more
than a certain amount of water.
When the tank is full and the cleaner no longer picks up
water, switch off the cleaner and empty the tank.

Installing the holder

the "
knob.
011609
When connecting an electric power tool, secure the
power supply cord and hose using the holders at a 70 cm
- 80 cm distance among the holders that are provided
with the cleaner so that the hose is not entangled by the
power supply cord.
Usage of base hook
CAUTION:
Be careful not to pinch your fingers when
•
closing the base hook. Failure to do so may
cause personal injury.
NOTE:
Do not apply an excessive force on the base hook.
•
The excessive force on the base hook may damage
the base hook. Close the base hook when not in
use.
Opening the base hook allows the following usage.
5
1
1. Holder