Baumatic BR180SS Instruction Manual page 30

18) The upper hinge needs to be rotated through 180 degrees from its
original position, before being refitted to the opposite side of the
cabinet. IMPORTANT: You must ensure that the hinge locates into the
relevant hole in the fridge door.
19) Refit the top cover and then retighten the screws at the front and
back of the top cover.
20) Re-fit the small plastic hinge cover that you removed in stage 3
and fit the larger plastic hinge cover that was supplied separately with
the appliance, to the top of the fridge door.
IMPORTANT: Check that both the upper and lower
doors open and shut correctly, without fouling, after
you have completed the door reversal process.
After the door has been reversed, you should check
the door seal of the fridge and freezer door. Neither
seal should be creased or crushed; otherwise there
will be a gap between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
30