Baumatic BR180SS Instruction Manual page 28

3) Gently prise off the plastic hinge covers at the top of the fridge
door, using a small flat-headed screwdriver. One of the plastic
hinge covers is small; this one will be reused later in the door
reversal process. A larger plastic hinge cover will be supplied
with the appliance separately and this should be used instead of
the existing one.
4) Remove the upper hinge using a medium sized cross-headed
screwdriver.
5) Carefully remove the fridge door from the middle hinge. The
door should be gently placed on some form of padded surface,
so that damage is not caused to it.
6) Remove the middle hinge door plug from the left hand side of
the fridge door. Remove the middle hinge door stopper using a
medium sized cross-headed screwdriver and then refit it onto the
opposite side of the fridge door. The middle hinge door plug
should also be refitted to the opposite side of the fridge door.
7) Unscrew and remove the middle hinge using a medium sized
cross-headed screw driver.
8) Carefully remove the freezer door from the bottom hinge. The
door should be gently placed on some form of padded surface,
so that damage is not caused to it.
9) Remove the lower hinge door plug from the left hand side of the
freezer door. Remove the lower hinge door stopper using a
medium sized cross-headed screwdriver and then refit it onto the
opposite side of the freezer door. The lower hinge door plug
should also be refitted to the opposite side of the freezer door.
10) Gently lean the appliance backwards at a 45° angle to allow the
lower hinge to be removed. IMPORTANT: One person should lean
back the appliance and support it whilst the lower hinge is being
removed (they should continue to support it in stages 11 and 12 as
well).
• Care should be taken whilst leaning the appliance back, to
make sure that damage is not caused to your flooring. You
can rest the fridge freezer on its original packaging to protect
your flooring.
11) Unscrew and remove the lower hinge using a medium sized
cross-headed screwdriver. Then refit and tighten the screws that
you have just removed into the same holes (this step is shown in
the line drawing on the next page).
28