C 10, C 11 Output Terminal Setting 11 And 12 - Hitachi J300 Series Instruction Manual

Extension
function
code
A terminal function is allocated to each of the output intelligent terminals 11 and 12. When using
a function other than the standard set functions or changing the terminal order, set the function for
each terminal.
Code
Output
terminal
setting
11 and 12
Set value
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Arrary of codes and intelligent terminals
Function name
C10 Output terminal setting 11
C11 Output terminal setting 12
Input terminal function list
Abbrevia-
Function name
tion
0 FA1 Frequency arrival signal
RUN Signal during running
1
2 OTQ Overtorque signal (Note)
NOTE: The torque of the overtorque signal can be set by the remote operator. The initial
values of motoring and regeneration are 100% torque. The overtorque signal can be
used only under the sensorless vector control.
Setting method
Press the key once for the terminal code to be set.
FUNC
The set values of the terminals which are set at present are displayed. Display the set value
of the terminal to be used from the function list indicated below by pressing the key
2
and and then press the
The display is returned to the code display and the terminal function is changed.
FUNC
Precautions for terminal setting
Same terminals cannot be set between
When moving a terminal name to another terminal, set another terminal which is not to be
ued at the setting source before inputting the set value to the setting destination and then
select the terminal name which is to be set at the setting destination.
Contents and display
Terminal Initial
rating plate setting
11 0
12 1
key.
FUNC
Enter the set value of the terminal name
to be used by pressing the keys
and
7-30
PCB terminal array
CM2
12
11
AL2
AL1
AL0
The setting method is the same
as that of the input terminals
to
and .
2
1
FUNC
.
.
1