Rs-485 Settings; Appendix; Appendix 1 Sadp Software Introduction - HIKVISION DS-2CD2012-I User Manual

User Manual of Network Camera

9.6 RS-485 Settings

Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS485
2. Set the RS-485 parameters and click
By default, the Baud Rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and
the Parity and Flow Control is None.
Note: The Baud Rate, PTZ Protocol and PTZ Address parameters should be exactly
the same as the PTZ camera parameters.

Appendix 1 SADP Software Introduction

 Description of SADP V 2.0
SADP (Search Active Devices Protocol) is a kind of user-friendly and installation-free
online device search tool. It searches the active online devices within your subnet
and displays the information of the devices. You can also modify the basic network
information of the devices using this software.
 Search active devices online
 Search online devices automatically
After launch the SADP software, it automatically searches the online devices
every 15 seconds from the subnet where your computer locates. It displays
the total number and information of the searched devices in the Online
Devices interface. Device information including the device type, IP address,
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
RS-485 Settings
Figure 9-12

Appendix

to save the settings.
68