Egtp S-Gw Configuration - Cisco ASR 5000 Series Administration Manual

Serving Gateway Configuration
7. The MME responds with a Create Bearer Response and Modify Bearer Request message.
8. The S-GW sends a Modify Bearer Response message to the MME.

eGTP S-GW Configuration

To configure the system to perform as a standalone eGTP S-GW, review the following graphic and subsequent steps.
M g m t
e N o d e B /
M M E
Step 1
Set system configuration parameters such as activating PSCs by applying the example configurations found in the
System Administration Guide.
Step 2
Set initial configuration parameters such as creating contexts and services by applying the example configurations
found in the Initial Configuration
Step 3 Configure the system to perform as an eGTP S-GW and set basic S-GW parameters such as eGTP interfaces and an IP
route by applying the example configurations presented in the
Step 4
Verify and save the configuration by following the instruction in the
OL-22986-01
1
L o ca l C o n te xt
M g m t In te rfa ce
E th e rn e t
In g re ss C o n te xt
S u b scrib e r C fg .
S -G W S e rvice
G T P -U S e rvice
e G T P In g re ss S e rvice
S 1 -U /S 1 1 In te rfa ce
E th e rn e t IP v 4 /v6
section of this chapter.
Configuring the System as a Standalone eGTP S-GW ▀
2
E g re ss C o n te xt
3
G T P -U S e rvice
e G T P E g re ss S e rvice
S 5 /S 8 In te rfa ce
IP v4 /v6
eGTP Configuration
Verifying and Saving the Configuration
Cisco ASR 5000 Series Serving Gateway Administration Guide ▄
P -G W
E th e rn e t
section.
section.